锡鸥牌“钛合金钢领”

锡鸥的牌钛合金钢领

采用高级钛合金材料研制而成。内部晶粒结构紧密、细致。热处理性能更稳定，变形量极小。

优良的使用性能：

·表面采用高科技复合镀工艺，镀上极薄一层具有自润滑作用的耐磨物质，并渗入钢领表面。上车走熟期极短。

·钢领与钢丝圈接触面属于异相摩擦，因此，不易发生粘连磨损，避免钢领跑道发生早期衰退现象，寿命与传统光面钢领相比可延长至5--7倍。

·卓越的表面处理工艺，使钢领表面几乎永不生锈。

·锡鸥牌钛合金钢领材质极为耐磨，因此，磨损量极微。在翻改纺纱品种时（指中、细支纱）不需拆下，必要时可在车上用柔软织物（或回丝）对跑道进行擦拭清理一次，并换上相应重量的（最好是同型号的）钢丝圈即可进行试纺。

·本钢领适合纺织任何纤维及各种支纱，对钢丝圈的选配无特殊要求，能使纺纱断头降低，毛羽减少。质量长期稳定在较好的水平上。

·该钢领质量差异小，为减少细纱锭差打下良好的基础。

The ring is made of high-grade Ti alloy with compact structure of the crystal grain, which allows stable heat treatment performance and little deflection.
Excellent performance:
The surface of the ring id coated with a paper-thin layer of selt-lubrication wearable material by high-etcg plating process, which allows short period to smooth running.
Out-of-phase friction between the ring and the ring trabeler allows long service life resulting from the reduction of the early rust which the wear and tear causes.Its service life is extended 5 to 7 times than that of the traditional ring.]
Advanced surface treatment process allows stainless.
XiOu Ti alloy ring with featrues of approved wear resistance makes it unnecessary to change ring when yarn counts changed.Clean the ring inside flange with soft fabric or cotton waste when it is necessary, and the replace the corresponding ring traveler, the dame type is recommended.
The ring is suitable for any fiber and all counts yarns without any special requirement for the selection of the ring traveler.Low end breakage and little hairines allow stable good quality.
High quality ring is a help to reduce the spindle discrepancy of the ring frame.