纺织专用系列电机--产品中心--无锡市华庄电机有限公司

您所在的位置：纺机网 >> 无锡市华庄电机有限公司 >> 纺织专用系列电机

产品推荐

产品分类

友情链接

联系方式

联系人：华庄电机
邮箱：
地址：无锡华庄小溪桥
电话：0510-85602521 0510-85602529
传真：0510-85602521

打印

分享到：

纺织专用系列电机

发布时间：2004-04-09

Y132 S₂-2

使用条件：
环境温度：随季节而变化，但不超过40℃
海拔：不超过1000米。
频率：50赫芝
电压：380伏。
接法：3千瓦及以下为Y接，4千瓦以下为△接。
工作方法：连续S1。
注：
如有特殊要求，请求于订货时提出。
如：
1.双轴伸或特殊轴伸。
2.异电压（如346、420、440、460伏）等。
异频率（60赫芝）
3.左出线（面对出轴，接线盒在左侧）。
4.不同绝缘等级，如F级。
5.不同防护等级，如IP54、IP55。

Conditions
Ambient temperature: It varies with seasons but not exceeding 40℃
Altitude: Altitude should be lower than 1000 meters above sea level.
Frequency:50 HZ
Rated voltage:380 V
Connection: Star-connection for 3KW and below whereas delta-connection for 4KW and above
Duty: Continuous(S1)
Remarks: When placing orders, please indicate the following special requirements, if any:
1.Double shaft-extension or special shaft-extension.
2.Different voltages such as 346V, 420V,440,460V and different frequency such as 60 HZ.
3.Terminal box to be placed on the left-hand side when facing the drive end.
4.Different insulation class such as class F.
5.Different protection class such as IP54, IP55.

概述：
   Y系列是一般用途的全封闭自扇冷鼠笼型三相异步电动机，它是我国统一设计的最新系列。防护等级为IP44。
   Y系列电机具有高效、节能、起动转矩大、性能好、噪声低、振动小、可靠性高、功率等级和安装尺寸符合IEC标准以及使用维护方便等优点。
   Y系列电机适用于不含易燃、易爆或腐蚀性气体的一般场所和无特殊要求的机械上，如：金属切削机床、泵、风机、运输机械、农业机械、食品机械等。由于电动机有较好的起动性能，因此也适用于某些对起动转矩有较高要求的机械，压缩机等。
   Y系列电机的型号由四部分组成；第一部分汉语拼音字母Y表示异步电动机；第二部分数字表示机座中心高（机座不带底脚时，与机座带底脚相同；）第三部分英文字母为机座长度代号（S-短机座、M-中机座、L-长机座），字母后的数字为铁心长度代号；第四部分横线后的数字为电动机的极数。
General
Y-Series Three-phase induction Motors the brand-new product developed by our country, are defined as totally enclosed, fan cooled, squirrel cage motors for general application. The protection class is IP44.
With high efficiency, energy-saving, high reliability, easy maintenance, the motors are designed to be large in starting torque, low in noise and small in vibration. The rated output and mounting dimensions agree with those recommended by IEC.
The motors find applications in the places where inflammable, explosive and corrosive gases are kept off as well as in the machinery without special requirements such as metal-cutting machine tools, pumps, blowers, transportation machinery, mixers, agricultural machinery and food machinery. Furthermore, the good starting performance makes the motor possible to be used in compressors, etc. which call for strict requirements of starting torque.
The type designation of the motors consists of four parts: Y standards for induction motor; 132 frame size (The frame size of the motor without feet is the same as that of motor with feet.) the third part is the length of frame(S-shrot frame, M-Medium frame, L-long frame) the figure close to it the length of core; the figure after the line the number of poles.